Low Temperature Incubator Calibration｜6-Point Temperature Measurement & Panel Verification

This record covers the calibration of a low temperature incubator, commonly used for cell culture, microbiology, and pharmaceutical storage. To ensure accuracy and stability, READY Biotech performed the following calibration / testing / validation procedures:

▣ Multi-Point Temperature Distribution Test

• Conditions set at 20°C, 40°C, and 60°C

• Six temperature sensors placed across upper, middle, and lower levels

• Data recorded every minute for 30 minutes after stabilization

▣ Panel Display Comparison & Accuracy Verification

• Measurements taken with a calibrated reference thermometer

• Compared incubator panel display with actual measured values

• Confirmed deviations within acceptance criteria

▣ Reporting & Compliance

• Full data curve and stability analysis provided

• Report structured to meet GMP / GLP compliance requirements

READY’s calibration and testing service ensures your low temperature incubator performs reliably, safeguarding experiment reproducibility and regulatory compliance.

☎︎ Contact Us：+886-2-8228-0131

✉︎ Email： Ready_lab@outlook.com